Sharp AR-M700U 3-16, Alarm display, Using the inserter, Load paper in the inserter, Inserter

INSERTER

■Alarm display

If the [START] key indicator on the inserter operation panel is blinking and the [PUNCH] key or [STAPLE] key indicator is also blinking or solidly lit, operation will not start when the [START] key is pressed. Resolve the problem as indicated below, depending how the indicators are lit or blinking.

[PUNCH]		[STAPLE] indicator				[START]
indicator						indicator
							Cause	Solution
							A paper size that cannot	Use paper that is a suitable
Any one of the indicators is solidly lit.						Blinks red	be fed has been loaded.	size for punching, stapling, or
								saddle stitching (page 3-3).
					Solidly		The paper type of the	Heavy paper cannot be
-	-		-	-		Blinks red	inserter is set to heavy	used.
					lit
							paper.
							The finisher or saddle	Remove the paper from
							stitch finisher tray is full.	the tray.
Blinking	-		-	-	-	Blinks red	The hole punch scrap	Discard the hole punch
							container in the punch	scrap (page 3-10).
							module on the finisher or
							saddle stitch finisher is full.
							The finisher or saddle	Remove the paper from
	Any one of the						stitch finisher tray is full.	the tray.
-					-	Blinks red
							The finisher or saddle	Replace the staple
	indicators is blinking.
							stitch finisher is out of	cartridge (page 3-7).
							staples.
							The saddle stitch tray on	Remove the paper from
							the saddle stitch finisher is	the saddle stitch tray.
-	-		-	-	Blinking	Blinks red	full.
							The saddle stitch finisher is	Replace the saddle stitch
							out of saddle stitch staples.	staple cartridge (page 3-8).

■Using the inserter

For paper sizes that can be stapled or punched, see the finisher and saddle stitch finisher specifications on page 3-2.

Some paper types cannot be stapled or punched (see "NOTES" on page 3-3). Do not use these paper types.

1 Load paper in the inserter.

NOTE

Paper guide

Load the paper face up.

When performing pamphlet stapling, place the paper so that the opened pages are face up as shown.

Adjust the paper guide to the size of the paper.

Pamphlet stapling can only be used when the saddle stitch finisher (AR-F16) is installed.

When using pamphlet stapling, stapling and punching cannot be used in combination.

3 Press the [START] key.

Make sure that the [START] key light is illuminated green and then press the [START] key.

2 Press the desired mode key.

Press key 2 on page 3-15for stapling or pamphlet stapling. Press key 1 on page 3-15for punching. The selected mode lights up.

3-16