Sharp AR-M620N, AR-M700U, AR-M550N, AR-M700N 3-18, Troubleshooting inserter problems, Inserter

INSERTER

Troubleshooting inserter problems

Check the list below before calling for service.

Problem		Check	Solution or cause
		The desired staple mode is not selected.	Select the desired staple mode at the
Stapling position is			operation panel of the inserter (page 3-15).
not	correct	The paper is not loaded in the correct	Load the paper correctly (page 3-16).
(including	saddle	position.
stitch).
		The paper is not loaded face up.	Paper must be loaded face up in the inserter
			tray (page 3-16).
		Are any inserter covers open?	Close all covers.
		"Disabling of inserter" is enabled in the key	Check the key operator programs and disable
The inserter does		operator programs.	"Disabling of inserter".
		A paper misfeed message appears.	Remove the misfed paper (page 3-17).
not operate.
			Make sure that the punch or staple key has
		The [START] key light is not illuminated.	been selected on the operation panel of the
			inserter (page 3-15).
			Do not use curled or folded paper. When the
Paper	misfeed		inserter is not going to be used for a long time,
		The paper is curled or damp.	remove the paper from the inserter, place it in
occurs
			a bag so that it does not absorb moisture, and
			store it in a dark place.

3-18