Sharp AR-M700U Loading Paper, Identifying the trays, Loading paper in paper tray 1 - tray, Tray

LOADING PAPER

If the paper runs out during printing, a message will appear in the display.

Follow the procedure below to load paper.

Identifying the trays

The trays are identified using numbers as shown below.

For the types and sizes of paper that can be used in each tray, see page 2-8.

1 Tray 1

This is the left large capacity tray.

2 Tray 3

3 Tray 4

4 Tray 2

This is the right large capacity tray.

5 Tray 5

This is an optional large capacity tray.

6 Bypass tray

NOTES

●Do not use curled or folded paper. Doing so may cause a misfeed.

●Do not place heavy objects or press hard on any tray which is pulled out.

●Do not place objects on the large-capacity tray. This may damage the tray or interfere with operation.

●Load paper with the print side face up. However, when the paper type is set to "PRE-PRINTED" or "LETTER HEAD", load the paper face down*.

*If the two-sided function is disabled using "DISABLING OF DUPLEX" in the key operator programs(page 11 of the key operator's guide), load the paper face up.

Loading paper in paper tray 1 - tray 2

A4 or 8-1/2" x 11" size paper can be loaded in tray 1. A4, B5 or 8-1/2" x 11" size paper can be loaded in tray 2. These are parallel large-capacity trays that allow a total of approximately 2000 sheets of SHARP standard paper (80g/m2 (20lbs.)) to be loaded. If you wish to change the paper size of tray 1 or tray 2, please consult your dealer (the paper size must be changed by a service technician).

1 Pull out paper tray 1-tray 2.

2 Load paper in the left and right trays.

Gently pull the tray out until it stops.

Indicator line

Indicator line

Lift the paper guide and load paper in tray 1.*1 Approximately 800 sheets of SHARP standard paper (80g/m2 (20lbs.)) can be loaded.

Be sure to return the paper guide to its original position after loading the paper.

Load paper in tray 2.*1

Approximately 1200

sheets of SHARP standard paper (80g/m2 (20lbs.)) can be loaded.

*1 The paper stack must not be higher than the indicator line.

2-2