Sharp AR-M700N, AR-M700U, AR-M550N, AR-M620N Staple cartridge replacement and staple jam removal

FINISHER AND SADDLE STITCH FINISHER

Staple cartridge replacement and staple jam removal

When a finisher is installed, a message will appear when the staple cartridge runs out of staples or a staple jam occurs.

Follow the procedure below to replace the staple cartridge or remove jammed staples.

■Replacing the cartridge in the finisher

1 Open the front cover of the finisher.	5 Pull the seal that holds the staples straight
	out.

2 Lower the blue lever in the stapler and slide out the staple cartridge.

3 Pull the empty staple case straight up and out of the cartridge.

4 Insert a new staple case into the cartridge. Push the staple case all the way in until it clicks into place.

Do not remove the seal holding the staples until the staple case is set in the cartridge.

6 Insert the cartridge all the way in until it clicks into place.

Insert the cartridge all the way in until it clicks into place.

7 Close the front cover of the finisher.

NOTE

Make a test print or copy in the staple sort mode to verify that stapling is performed properly.

3

3-7