Sharp AR-350, AR_M280 Upper exit tray extension, Finisher, Mail-bin stacker, Multi purpose drawer

B/W scanner module/DSPF

This unit is a monochrome scanner that allows automatic feeding of sheet originals and continuous scanning. The B/W scanner module/DSPF (Dual Single Pass Feeder) can scan two-sided sheet originals and can scan both sides at a time. Also a flat bed type document glass is provided in this unit for scanning an original that cannot be fed such as a book and thick original.

Upper exit tray extension

Mount this unit to the upper paper exit tray.This unit is needed for output of 11" x 17" (A3) paper.

Finisher

Sorted output sheets or grouped output sheets by page are offset stacked so that each set can be taken out easily.

Also sorted output sheets can be stapled.

Mail-bin stacker

This unit is an output sheet sorting unit that contains seven bins. When printed sheets are output in the printer mode, a bin to which printed sheets are to be deposited can be specified in the printer driver. The bins can be classified by persons or by sections depending on users so that the users deliver their printed sheets to their specified bin. Sorted output separated from the other users, therefore, can be performed.

Output sheets in the copy and fax modes are deposited in the top tray other than these seven bins.

Stand/MPD & 2000 sheet paper drawer

This is a paper feed unit that contains two paper trays.The upper tray is equivalent to the multi purpose drawer. The lower tray holds approximately 2000 sheets of 20 lbs. (80 g/m2) paper.

PART NAMES AND FUNCTIONS

Multi purpose drawer

Holds paper. Up to 500 sheets of 20 lbs. (80 g/m2) paper can be loaded. Also special papers such as envelopes (standard sizes only) and Japanese postcard can be set.

Stand/3 x 500 sheet paper drawer	1
This is a paper feed unit that contains three paper

trays.The upper tray is equivalent to the multi purpose drawer. Each of the lower two trays holds up to 500 sheets of 20 lbs. (80 g/m2) paper.

Saddle stitch finisher

Sorted output sheets or grouped output sheets by page are offset stacked so that each set can be taken out easily. Also sorted output sheets can be stapled at the edge or at the center for center-stapled binding.

In addition, if a punch module is installed as a peripheral unit, punch holes can be made in the output sheets for filing.

Duplex module

Unit for automatic two-sided printing.

Duplex module/bypass tray

This module is equipped with a unit for automatic two-sided printing and a bypass tray manual paper feeding.

Exit tray

Mounted to the paper output port of a duplex module or a duplex module/bypass tray.

For installation of a peripheral unit, installation of some other peripheral units may be needed together and installation of some peripheral units may not be possible together. See page xx, “COMBINATION OF PERIPHERAL UNITS.” Peripheral units are basically optional but some units may be provided as standard units depending on the main unit model.

1-9