Sharp AR_M280 Misfeed in the paper feed area, Misfeed in paper tray, Pull out the duplex module

MISFEED REMOVAL

Misfeed in the paper feed area

NOTE

Do not pull out the paper tray first. Paper may be misfed between the paper tray and the paper feed area in the printer. Before pulling out the paper tray, be sure to open the left side cover and check to see if paper is misfed (steps 1 and 2). If you pull out the paper tray without checking, paper may be torn and it may be difficult to remove it.

■Misfeed in paper tray 1

1 Pull out the duplex module.

Hold the knob and gently open the module.

If the machine is not equipped with the duplex module, open the side cover similarly.

2 Remove the misfed paper.

Be careful not to tear the misfed paper during removal.

NOTE

Since paper may be misfed in the inner part, check carefully and remove it.

If misfed paper is not found in step 2, pull

3 out paper tray 1 and remove the misfed paper.

Be careful not to tear the misfed paper during removal.

4 Gently close the paper tray.

Push back the paper tray all the way into the machine.

5 Gently close the duplex module.

If the machine is not equipped with the duplex module, close the side cover similarly.

After closing the duplex module, confirm that the misfeed message is cleared and that the normal display appears.

NOTE

If paper drops beyond the rear side of the paper tray that has been pulled out, remove the paper tray and then remove the paper. (For removal of the paper tray, see the illustration below.)

After pulling out the paper tray until it stops, gently lift and pull the tray to remove it. To reattach the removed paper tray, insert it at an angle and then push it back horizontally in the reverse procedure of removal.

4-4