
PART NAMES AND FUNCTIONS
Using the touch panel
■How to use the touch panel
■ Selection of function |
[Example 1]
JOB QUEUE | SETS / PR | ||
COPY | 003 | / 00 | |
SHANE COFFEY | 003 | / | 00 |
054234 | 010 | / | 00 |
CLIFF QUIROGA Beep003 / 00
tone
[Example 2]
1/13 COMPLETE
You can easily set or cancel a function by touching a key on the display with a finger. The touch panel operation can be confirmed with a beep tone and highlighted display.
If any key is disabled on each screen, the key is displayed gray. If you press the key, two short beeps will be sounded.
[Example 1] |
1
If any key is highlighted in the initial setting of each setting screen, the function will be registered when you touch the [OK] key without additional operation.
[Example 2]
DUAL PAGE
When using the copier feature or the facsimile
The beep tone of key touch can be disabled by a key operator program. (See page xxxx of the Key Operator’s guide.)
The touch panel (display) illustrated in this operation panel is a conceptual illustration.
COPY
MULTI SHOT
feature, the functions shown below which can be set by only touching the relevant key in the special feature screen can be canceled by touching the key again (canceling highlighted display).
Copier feature | Facsimile feature |
|
|
Dual page copy | Polling |
B/W reverse | Own number print |
Rotation copying in | Page cutoff |
| |
Centering |
|
|
|
[Example 3]
DUAL PAGE
COPY
MULTI SHOT
DUAL PAGE
COPY
MULTI SHOT
When using the copier feature or the facsimile feature, if a special function is set, the corresponding function icon will appear. If this icon is touched, the setting screen of the function (or a menu screen) will appear, allowing the settings to be checked or adjusted and the function to be canceled easily.