Sharp AR_M280 1-12, Part Names And Functions, Ready, Job status screen, Paper Jam Add Paper

PART NAMES AND FUNCTIONS

Menu group list and supplementary explanation of key operation (when using the operation panel on the main unit)

The menu groups are classified into the following five groups as shown below. These menu groups are selected by pressing the [MENU] key. If the [OK] key is pressed when the desired menu screen is displayed, a message indicating required operation will appear.

READY.

[MENU] key

Job status screen

The message "WARMING UP" displayed when the power is turned on and the list of the current job and the reserved jobs or the list of completed jobs are displayed on the job status screen. Various messages are displayed on the job status screen. Examples of messages are shown below.

(Display example)

WARMING UP.

READY.

FROM TRAY #

CHANGE THE TONER CARTRIDGE.

PAPER JAM.

ADD PAPER.

The printer is warming up to allow printing.

The printer is ready to print.

The printer is currently executing printing.

Toner runs out. Replace the toner cartridge. (See page xxxx.)

A misfeed has occurred. (See page xxxx.)

Paper runs out. Load paper. (See page xxxx.)

PRINT HOLD

[MENU] key

[ADD PAPER] of status display

When the status display shows [ADD PAPER], the specified size paper is not loaded. In this case, printing is suspended until paper is loaded and another reserved job data will be printed if possible. (If paper runs out during printing, another job data will not be printed.) If you wish to change the paper size to resume printing, see "Method of setting paper size and type" on page xxxx.

Print hold

If the job retention function is used from your computer, print data will be stored in the printer as a hold job.

The job retention function can be used only if the printer is equipped with a hard disk drive as a peripheral unit. (See page xxxx.)

CONDITION SETTINGS

[MENU] key

Configuration settings

The printer configuration settings are used for basic printer settings. (See page xxxx.)

CUSTOM SETTINGS

[MENU] key

KEY OPERATOR

PROGRAMS

[MENU] key

Custom settings

Custom settings are used to make settings based on the conditions of use of customers. (See page xxxx.)

Key operator programs

These are settings used by key operators (administrators of this product). For the setting, see the "Key Operator's Guide". (See page xxxx.)

1-12