Sharp AR-350, AR_M280 operation manual Finisher, Supplies

FINISHER

If the finisher is installed, the offset function can be used. Each set of printed sheets is stacked offset from the previous set so that it can be easily taken out. Also each set of sorted sheets can be stapled.

Part names

Knob

Hold this knob to open the finisher for misfeed removal.

Top cover

Open for misfeed removal.

Staple unit

Pull out to replace the staple cartridge or to remove jammed staples.

Top tray

Paper output from the printer, copier, and fax features can be delivered here.

The tray is extendable. To print onto large paper (8-1/2" x 14", 11" x 17", B4 or A3), extend the tray.

Stapler compiler Paper to be stapled is stacked temporarily.

Offset tray

The offset function and the stapling function can be used only in this tray.

NOTES

●Do not put pressure on the finisher (particularly each tray).

●Be careful about the offset tray during printing because the tray moves up and down.

●Some other peripheral units may be needed for installation of the finisher and some peripheral units cannot be installed together with the finisher. For combination of the peripheral units, see the list of combination of peripheral units on page xxxx.

Specifications

5

Name	Finisher
Number of trays	2
Exit system	Print face down
Tray type	Top tray: normal tray, Lower tray: offset tray
Paper capacity	Top tray: 500 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m2)
	Lower tray: 750 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m2)
Paper size	Top tray: Max. 11" x 17" or A3, Min. 5-1/2" x 8-1/2"R or A5R
	Lower tray: 8-1/2" x 11", A4 or B5R
Paper weight	Top tray: 15 to 54 lbs. or 56 to 205 g/m2
	Lower tray: 15 to 34 lbs. or 56 to 128 g/m2
Paper type	Top tray: same as the specifications of paper for feeding in the main unit
	Lower tray:
Paper limit detection	Provided in both the top tray and the lower tray
Offset function	Provided in the lower tray only, offset amount: 1.2 inch (30 mm)
Paper size for stapling	8-1/2" x 11", A4, and B5
Stapling capacity	30 sheets (20 lbs. or 80 g/m2)
Stapling position	Three types (one at rear, one at front, two at center)
Reference paper position	Center
Power supply	Drawn from the power supply unit (peripheral unit)(See page xx.)
Dimensions	xx-x/x” (W) x xx-x/x” (D) x xx-x/x” (H) (xxx mm (W) x xxx mm (D) x xxx mm (H))
Weight	Approx. xxx lbs. (xx kg)

Specifications are subject to change for improvement without notice.

Supplies

For the finisher, the following staple cartridge is needed as supplies.

●Staple cartridge (Approximately 3,000 staples x 3) xxxx

5-9