Siemens ST PCS 7 manual Power module PM-E, 11/65, Connection module

	© Siemens AG 2007
			Process I/O
			Dezentrale Peripherie ET 200pro
			Power module PM-E
■Overview		■Selection and Ordering Data Order No.

The power module PM-E DC 24 V is used within an ET 200pro station when generating 24 V DC load voltage groups for elec- tronics modules.

You can position power modules in an ET 200pro station any- where to the right of the interface module. The first power mod- ule is already integrated in the interface module.

Each power module which you install in the ET 200pro station in- terrupts the load voltage busbar, and opens up a new potential group (common potential) for the load voltage supply 2L+. All subsequent load voltages of the electronics modules are fed from this power module. Each power module has a replaceable fuse for protecting the device. Only line protection according to DIN VDE 0100 need be provided externally in addition.

Power module
Power module PM-E DC 24 V	6ES7148-4CA00-0AA0	B)
For generating 24 V DC load volt-
age groups for electronics mod-
ules within an ET 200pro station.
Accessories
Connection modules for power
module
• Connection module CM PM-E	6ES7 194-4BA00-0AA0	B)
ECOFAST
for supply of 24 V DC load volt-
age, 1 ECOFAST Cu connection
• Connection module CM PM-E	6ES7 194-4BC00-0AA0	B)
direct
for supply of 24 V DC load volt-
age, up to two M20 cable
glands
• Connection module CM PM-E	6ES7 194-4BD00-0AA0	B)
7/8"
for supply of 24 V DC load volt-
age, 1 x 7/8"
Spare fuse	6ES7 194-4HB00-0AA0

12.5A fast-blow, for interface and power modules, 10 units per pack

Further accessories

For plugs, cables and further accessories, see Catalog IK PI or Mall/CA 01 under "Distributed I/O / ET 200pro"

B) Subject to export regulations: AL: N, ECCN: EAR99H

The electronics/sensor supply 1L+ is not interrupted by the power module, it is looped through.

The power module is fitted on the associated bus module when delivered.

■Technical specifications

For detailed technical specifications of the power module PM-E, see:

•Catalog IK PI

•Mall/CA 01 under "Distributed I/Os / ET 200pro"

■Accessories

Connection module

The connection module for the power module PM-E is used to connect the load voltage 2L+. It is fitted on the power module.

The module must be ordered separately, and is available with the following types of connection:

• CM PM-E direct	11
• CM PM-E ECOFAST

• CM PM-E 7/8"

Siemens ST PCS 7 · November 2007

11/65