Toshiba 4511, 3511

November 2003 © TOSHIBA TEC 3 - 17 e-STUDIO3511/4511 ADJUSTMENT

(e) Image location of secondary scanning direction

1. While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)

2. Place Test Chart No. TCC-1 on the original glass (with the arrow positioned at the left rear

side).

3. Press [FAX] → [START] to make a copy at the mode of A4/LT, 100%, Black and Text/Photo.

4. Measure the distance D from the top paper edge to the 10 mm line of top grid pattern on the

copy with a ruler.

5. Check if the distance D is within 10±0.5 mm.

6. If not, use the following procedure to change values and repeat step 3. to 5. above.

<Procedure> (Adjustment Mode) → (Key in the code [305]) → [START]

→ (Key in a value (acceptable values : 92 to 164))

→ [ENTER] or [INTERRUPT] (Stored in memory)

* The larger the adjustment value is, the longer the distance D becomes (approx.

0.14 mm/step).

(f) Top margin

1. While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)

2. Open the platen cover or RADF.

3. Press [FAX] → [START] to make a copy at the mode of A3/LD, 100%, Black, Text/Photo and

lower drawer.

4. Measure the blank area E at the leading edge of the copied image.

5. Check if the blank area E is within the range of 3±0.5 mm.

6. If not, use the following procedure to change values and repeat the steps 3. to 5. above.

<Procedure> (Adjustment Mode) → (Key in the code [430]) �� [START]

→ (Key in a value (acceptable values : 0 to 255))

→ [ENTER] or [INTERRUPT] (Stored in memory)

→ (“100% A” is displayed.)

* The larger the adjustment value is, the wider the blank area becomes (approx.

0.04 mm/step).

Feeding direction

Fig. 3-405