Toshiba 4511, 3511

e-STUDIO3511/4511 ADJUSTMENT 3 - 30 November 2003 © TOSHIBA TEC

3.5.11 Adaptation to highlighter

Four modes of one touch adjustment are performed and each mode can be switched into two modes;

highlighter 1 or 2. This adjustment is performed when the reproduction mode for highlighter is needed.

Code

1769

1770

1771

1772

Remarks

0: Default (Vivid / Clear / Warm / Cool)

1: Highlighter 1

2: Highlighter 2

One touch adjustment

Vivid

Clear

Warm

Cool

Make a test copy and compare the image obtained with the current settings; if necessary, make

adjustment using the following procedure.

Procedure is same as that of “3.5.3 Color balance adjustment”.

Notes:

1. When this adjustment is performed, “3.5.1 Automatic gamma adjustment (Black Mode)” (05-580)

needs to be performed since the reproduction of density at Black Mode varies. The result of this

adjustment is not reflected to color/black integrated pattern. Namely, each automatic gamma

adjustment of Black Mode (05-580) or of Color Mode (05-1643) needs to be performed individually

after this adjustment.

2. After this adjustment, set “1” in 08-595 so that the correction result of the Black Mode is not reflected

on “Automatic Calibration”.

3. The setting value must increase as the beam level number (0 to 4) becomes higher. Do not increase

this order when setting the values.

4. Usually, beam level 4 is most effective on all black modes.

Code

667-0

667-1

667-2

667-3

667-4

Remarks

The smaller the value is, the smaller the beam width

becomes. Therefore, the smaller dot is reproduced

accordingly. Acceptable values: 0 to 255.

(Default: Level 0/4: 0, Level 1/4: 63, Level 2/4: 127,

Level 3/4: 191, Level 4/4: 255)

Item to be adjusted

Beam level 0/4

Beam level 1/4

Beam level 2/4

Beam level 3/4

Beam level 4/4

Note:

The color may not always be reproduced precisely due to the characteristics of fluorescent ink.

3.5.12 Beam level conversion setting

The beam level for 4 divided smoothing is set at the Black Mode. This adjustment enables to adjust

the dot size.