Toshiba 4511, 3511

November 2003 © TOSHIBA TEC 2 - 5 e-STUDIO3511/4511

ERROR CODE AND SELF-DIAGNOSTIC MODE

Door open jam:

(1) The finisher has been released from the equipment during

printing. [MJ-1022]

(2) The upper/front cover of the finisher section or the upper/

front door of the puncher section has opened during

printing. [MJ-1023/1024]

Stapling jam: Stapling is not performed properly.

[MJ-1022/1023/1024]

Early arrival jam: The inlet sensor detects the paper earlier than

a specified timing. [MJ-1022/1023/1024]

Stack delivery jam: It cannot deliver the stack of paper on the

intermediary process tray to the stack tray. [MJ-1022]

Stapling jam: Stapling is not performed properly. [MJ-1024]

Door open jam: The delivery cover or inlet cover has opened dur-

ing printing [MJ-1024].

Power-ON jam: Paper exists at No.1 paper sensor, No. 2 paper

sensor, No.3 paper sensor, vertical path paper sensor or

delivery sensor when power is turned ON. [MJ-1024]

Transport stop jam: The paper which passed through the inlet

sensor does not reach or pass No.1 paper sensor, No. 2 paper

sensor, No.3 paper sensor or delivery sensor. [MJ-1024]

Transport delay jam: The paper which has reached the inlet

sensor does not pass through the inlet sensor. [MJ-1024]

Print end command time-out jam: The printing has not finished

normally because of the communication error between the SYS

board and LGC board at the end of printing.

Receiving time time-out jam: The printing has been interrupted

because of the communication error between the equipment

and finisher when the paper is transported from the equipment

to the finisher.

Stack return jam: It cannot load the paper which passed through

the delivery roller on the intermediary process tray. [MJ-1022]

Ready time time-out jam: The equipment judges that the paper

transport to the finisher is disabled because of the communication

error between the equipment and finisher at the start of printing.

Paper remaining on the transport path: The multiple feeding of

preceding paper caused the misfeeding of upcoming paper.

Paper remaining on the transport path: The multiple feeding of

preceding paper caused the misfeeding of upcoming paper

(redetection after no jam is detected at [EB50]).

Finisher jam

(Finisher section)

Finisher jam

(Saddle stitcher

section)

Other paper jam

Finisher jam

(Finisher section)

Finisher jam

Paper transport

jam

EA40

EA50

EA60

EA70

EA80

EA90

EAA0

EAB0

EAC0

EAD0

EAE0

EAF0

EB30

EB50

EB60

Ch. 5.1.7 (2)

Ch. 5.1.7 (3)

Ch. 5.1.4

Ch. 5.1.7 (5)

Ch. 5.1.7 (2)

Ch. 5.1.7 (5)

Ch. 5.1.3

Trouble-

shooting

Error code Classification Contents