Toshiba 4511, 3511 manual ()

November 2003 © TOSHIBA TEC 2 - 33 e-STUDIO3511/4511 ERROR CODE AND SELF-DIAGNOSTIC MODE
Procedure 14
Procedure 10
Procedure 6
[0][5]
[POWER]
[POWER]OFF/ON
(Exit)
[Digital key]
(Code) [START]
()
Automatic
adjustment
(
[FAX] [START]
)
(Test copy)
*[CANCEL] or [CLEAR]
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[START] [START][START]
[ENTER] or [INTERRUPT]
(Value unchangeable)
()
Value
displayed
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code) [START] [START]
[Digital key]
(Sub code)
[CANCEL]
(Corrects value)
[CLEAR]
(Corrects value)
[ENTER]
or
[INTERRUPT]
Stores value
in RAM
()
[FAX]
[START]
(Test copy)
()
[UP] or [DOWN]
(Adjust a value)
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code) [START]
()
Automatic
adjustment
[FAX]
[START]
(Test copy)
*[CANCEL] or [CLEAR]
[CANCEL]
()
()
[ENTER]
Stores value
in RAM
Procedure 7
Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment mode.
In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after it has
become ready state and then start up the adjustment mode again.
* When the automatic adjustment ends abnor mally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
* When the automatic adjustment ends abnor mally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.