November 2003 © TOSHIBA TEC 3 - 85 e-STUDIO3511/4511 ADJUSTMENT
(5) Turn ON the power.
(6) Press SW1 on the saddle stitcher controller PC board so that the feed motor (M1) starts to rotate.
(Press SW1 three seconds or more if LD paper is used.)
(7) Open the inlet cover and insert two sheets of paper. Push them in by hand until the front edge of
the sheets push against the paper positioning plate.
(8) Close the inlet cover.
(9) Press SW1 on the saddle stitcher controller PC board.
• The saddle stitcher unit will “stitch” the sheets, and fold and deliver the stack automatically.
(10) Measure the distance (L) between the stitching position and the folding position. Then perform
“positive width adjustment” or “negative width adjustment” to suit the relationship between the
stitching position and the folding position.
• If the stitching position is below the folding position, perform “positive width adjustment.”
• If the stitching position is above the folding position, perform “negative width adjustment.”
Fig. 3-1405
Mark
Folding position
Stitching position
Unit: mm
Example: If L is 1 mm, provide "+1 mm".
Positive Width Adjustment Negative Width Adjustment
Mark
L
L
Stitching position
Folding position
Unit: mm
Example: If L is 0.5 mm, provide "-0.5 mm".