November 2003 © TOSHIBA TEC 4 - 17 e-STUDIO3511/4511 PREVENTIVE MAINTENANCE
Apply grease on the
inner surface Apply white grease
Fig. 4-208
*e1. Separation roller (SFB)
Apply an even coat of grease (Alvania No.2) to all round the inside of the spring.
When replacing the separation roller, apply adequate amount of white grease (Molykote
HP-300) on the places of the holder shown in the figure (4 places).
Note:
Make sure that the grease does not adhere to the roller surface. Wipe it off with alcohol if
adhered.
Fig. 4-209 Fig. 4-210
*c3. Install the 2nd transfer front guide after the cleaning of the paper dust removal brush.
Push the 2nd transfer front guide to the transfer belt unit and fix it securely as shown in the
figure below.