Toshiba 4511, 3511

e-STUDIO3511/4511 TROUBLESHOOTING 5 - 38 November 2003 © TOSHIBA TEC

[EAA0] Power-ON jam

MJ-1024

Is there any paper remaining on the transport path in the finisher or saddle stitcher section?

YES Remove the paper.

Is any of the connectors J9, J10 and J13 on the saddle stitcher controller PC board disconnected?

Is the harness between the saddle stitcher controller PC board and each sensor (No.1 paper sensor

[PI18], No.2 paper sensor [PI19], No.3 paper sensor [PI20], the vertical path paper sensor [PI17]

and the delivery sensor[PI11]) open circuited?

YES Connect the connectors securely. Replace the harnesses.

Is each of the sensors (No.1 paper sensor, No.2 paper sensor, No.3 paper sensor, the vertical path

paper sensor, and the delivery sensor) working properly?

(Check the movement of the actuator.)

NO 1. Connect the connectors of the sensors securely.

2. Attach the actuators securely if their shafts are out of place.

3. Replace the sensors.

YES

Replace the saddle stitcher controller PC board.

[EAB0] Paper transport stop jam

MJ-1024

Is there any paper remaining on the transport path in the finisher, saddle stitcher section or equipment?

YES Remove the paper.

Is the connector J708 on finisher controller PC board disconnected?

Is the harness between the finisher controller PC board and inlet sensor [PI33] open circuited?

Is either of the connectors J9 or J10 on the saddle stitcher controller PC board disconnected?

Is the harness between the saddle stitcher controller PC board and each sensor (No.1 paper sensor

[PI18], No.2 paper sensor [PI19], No.3 paper sensor [PI20] and the delivery sensor [PI11])

open circuited?