e-STUDIO3511/4511 ADJUSTMENT 3 - 76 November 2003 © TOSHIBA TEC
3.13.5 Releasing the stack tray guide lever fixing plate
(1) Remove the right inner cover and the rear
cover.
(2) Remove the finisher control PC board, PC
board bracket and sensor PC board.
(3) Remove the stack tray.
(4) Remove the stack tray drive unit.
(5) Place the stack tray guide lever fixing plate
so that it is in view through the hole in the
side plate (front, rear). Then remove the
fixing screw. (Perform the same for the front
and the rear.)
Note:
When removing the mounting screw, be sure to
hold the stack tray guide lever up from below.
Screw
Stack tray guide lever
fixing plate
Fig. 3-1314
Fig. 3-1315
Stack tray
guide lever