e-STUDIO3511/4511 TROUBLESHOOTING 5 - 32 November 2003 © TOSHIBA TEC
[EA40] Door open jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment?
YES Remove the paper.
NO
Is the finisher connected with the equipment?
NO Connect the finisher with the equipment.
YES
Is the connector J11 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and joint sensor (S4) open circuited?
YES Connect the connector securely. Replace the harness.
NO
Is the joint sensor working properly?
NO 1. Connect the connector of the joint sensor securely.
2. Replace the joint sensor.
YES
Replace the finisher controller PC board.