November 2003 © TOSHIBA TEC 3 - 93 e-STUDIO3511/4511 ADJUSTMENT
05/03
(7) Loosen 2 screws that were tighten in step
(6).
(8) Loosen 1 screw and turn the adjustment
fixing bracket in the direction of an arrow.
(9) Turn the adjustment screw. Since this is a hex-head screw, turn it based on each face of the hex
head.
• If the transfer belt contacts with the rear regulation plate or the gap between the transfer belt
and the rear regulation plate is less than 0.2 mm, rotate the adjustment screw clockwise
(viewing from below) five-sixth turn.
Fig. 3-1605
Less than 0.2mm
Adjustment screw
Fig. 3-1606
Fixing bracket