Toshiba 4511, 3511

e-STUDIO3511/4511 FIRMWARE UPDATING 6 - 28 November 2003 © TOSHIBA TEC

* Connect the finisher interface cable with the equipment after removing the finisher rear cover.

(4) Connect the download jig with the jig connector on the finisher control PC board.

[MJ-1023] [MJ-1024]

Finisher rear cover Finisher rear cover

Connector

Finisher firmware (MJ-1023/1024) and saddle stitcher firmware (MJ-1024 only) are written on the

finisher ROM. These two kinds of firmware can be updated individually by installing the download jig

to the finisher control PC board.

Tip:

The following updates are needed according to the finisher model.

• MJ-1023 (Console type):

Only the update of “Finisher firmware” is needed.

• MJ-1024 (Console type with the saddle stitcher):

Two kinds of update “Finisher firmware” and “Saddle stitcher firmware” are needed.

(1) Install the ROM to the download jig.

Make sure the direction is correct ( Page 6-3).

(2) Turn OFF the power of the equipment.

(3) Take off the finisher rear cover.