Appendix 5 | System Mode |
A5.5 Test Print (Cont.)
Note:
The label length (pitch) will be 1300mm if a SIMM is added to the printer
TYPE[S] NO CUT
Select the issue mode for the print test: “[S] NO CUT” (Batch mode without cutting) or “[C] WITH CUT” (Cut Mode).
After selecting the issue mode, press the PAUSE key.
BACK FEED YES
Specify whether a back feed will be performed when printing the test print. Select “YES” for back feeding.
After selecting the back feed option, press the PAUSE key.
QUALITY HIGH
Select the print quality for the test print: “HIGH” (ribbon saving disabled) or “NORMAL” (ribbon saving enabled).
If “HIGH” is chosen, print quality is higher.
After selecting the print quality, press the PAUSE key.
LABEL LEN 102mm
Select a label size for the test print. The acceptable values are 10mm to 1050mm.
After selecting the label size, press the PAUSE key.
PAPER FEED
To feed the media before the test print, press the PAUSE key. If media feed is not necessary, select “PAPER NO FEED” using either FEED or RESTART key.
The message returns to “<3> TEST PRINT”.
Printing out the Slant Line Pattern
<3>TEST PRINT
After “<3> TEST PRINT” is shown, press the
PRINT CONDITION
Test Print: Slant Line Pattern
Press the FEED key again.
SLANT LINE(K)
PAUSE
key.
Press the PAUSE key to start printing the slant line pattern for black.
After the printing completes, the message returns to “<3> TEST PRINT”.
Press the PAUSE key. “SLANT LINE K” appears again. Press the FEED key.
Note:
See A5.7.6 for further information.
102
