Toshiba CB-416-T3-QQ A1.3.3 Detection Area, Reflective Sensor, A1.3.4 Effective Print Area

	Appendix 1	Specifications
A1.3.3 Detection Area of the	The Reflective Sensor is movable from the left edge to the center of
Reflective Sensor	media.
	The reflection factor of the black mark must be 10% or lower with a
	waveform length of 950 nm.

The Reflective Sensor should be aligned to the center of the black mark.

Sensor positioned		Center of Media	Detecting the black
			mark on the back
at the center
Min. 2.0mm
	Min. 12mm		Media Feed
			Direction
		Sensor movable
		within this range

A1.3.4 Effective Print Area

Notes:

The figure below illustrates the relation between head effective print width and media width (when the four print heads are center-aligned in the X direction).

Out of Print				Out of Print
Range				Range
	4mm	101.6mm + 0.2	4mm
		(Head Effective Print Range)
		110mm
		(Max. Media Width)

The figure below shows you the effective print area on the media.

Area detected

∙Printing quality in the shaded area is not guaranteed.

∙Printing quality in the 1-mm width area around the media is not guaranteed in addition to the shaded area.

∙The center of media is positioned at the center of the print heads.

∙Printing outside of the effective print area may cause print failure even on the guaranteed print area.

∙If a roll of tags has rectangular holes, print quality in the 1-mm width around the hole is not guaranteed.

Start Line

1.5mm from the left edge of media

1mm	Media Height
	10mm to 1050mm
Guaranteed Print Area
Area detected	1.5 mm from
1mm	the right edge
	of media
	Media Feed
	Direction

Media Width

(including backing paper width)

1mm

1mm

77