Chapter 2 Printer Installation

2.5Loading the Media (Cont.)

Note:

Make sure that the leading edge of media is cut straight before inserting the media into the printer, as this may cause a media jam.

RightWrong

CAUTION!

Do not over tighten the two screws, as this may cause damage to the Media Guides.

14Loosen the two screws. Slide the Media Guides in the direction of the arrows below until they stop (completely open).

Screw

Screw

Media Guides

15Unroll about 1.5 to 2 inches (40 to 50cm) of the media.

16Insert the media into the Media Inlet. Make sure that the media passes under the Media End Sensor, the media sensor and the Media Pressure Plate.

Media End Sensor

Media Sensor

Media Pressure Plate

Important!

According to the media is loaded, adjust the position of the media sensor. See Section 2.6 for more detail.

Whenever the type of media is changed, adjust sensitivity of the media sensor. See Section 2.7 for more detail.

17Slide the Media Guides in the direction of the arrows below until both guides come in contact with the media (media should be in center of media path). Hand tighten the two screws.

Screw

Media Guide

Media Guide

Screw

 

14

Page 22
Image 22
Toshiba CB-416-T3-QQ owner manual RightWrong