Toshiba CB-416-T3-QQ owner manual A5.7.3 Cut Operation Example, A5.7.4 Pulse Motor Speed

Appendix 5 System Mode

A5.7.3 Cut Operation Example

A

B

A

A

A

B

A

A

B

B

A B

B

B

1In an idle state.

2Completes printing Label (A), and starts printing Label (B).

3Printing Label (B).

4Completes printing Label (B).

5Cuts the Label (A).

6Feeds Label (B) to the Cut Position, and cut it off.

7Feeds the label to the Home Position.

A5.7.4 Pulse Motor Speed

∙Usually “AUTO” should be selected. Depending on print patterns, the colors may not be aligned, and the pulse motor speed fine adjustment should be made.

∙The pulse motor speed adjustment allows more precise color registration. However, if the pulse motor speed needs changing, please contact an authorized service representative.

A5.7.5 X-Coordinate Fine Adjustment

The X-coordinate fine adjustment is made to adjust the X-coordinate of the drawing horizontally. The X- coordinate fine adjustment should be made in the effective print range. (If a field reaches the coordinate less than “0” after the fine adjustment is made in the negative direction, it is adjusted in the negative direction.)

A5.7.6 Magnified Views of Slant Line Pattern

∙1-Dot Slant Line (Black Area Ratio: 16.7%)

∙3-Dot Slant Line (Black Area Ratio: 16.7%)

108