Chapter 3 | Printing |
3.6.4Issue Settings
Note:
The settings made in this section can be saved in the file as the printing preferences for a particular print job. See Section 3.3.4 for more detail.
Note:
Please select Batch Mode (with Back Feed), if the Cutter Module (option) is installed on the printer.
Note:
DIP Swtich A Switch 2 must be ON to enable the cutter. See Appendix A2 for the setting of the switches.
Note:
When selecting 90° for the orientation of the bar font, select 4 inches/sec.
Issue mode, cut interval and print speed can be specified.
Click the Issue Mode down arrow, and select either Batch Mode (with Back Feed) or (no Back Feed).
In Cut, Disabled is selected by default.
However if the Cutter Module (option) is installed on the printer, click the Cut down arrow, and select one of the following options:
∙Select After Every Label, if a cut is required after each label is printed.
∙Select After Entire Job, if a cut is required after the entire print job is printed.
∙Select Specified Interval, if a cut is required after the number of labels, specified in Interval is printed. The cut interval option defaults to 3. In other words, cutting is performed every third label. The value in Interval can be changed by entering a new value.
Click the Print Speed down arrow, and select either 6 inches (152.4mm)/s or 4 inches (101.6mm)/s.
55
