Chapter 3

Printing

This section describes how to specify the print method, sensor, and label gap.

Click the Stock tab to open the Stock property page.

3.6.1Print Method

Note:

The setting made in this section can be saved in the file as a preferred setting for a particular print job.

See Section 3.3.4 for more detail.

Click the Print Method down arrow, and select Thermal Transfer (Ribbon Save A).

3.6.2Sensor

Notes:

See Sections 2.5 and 2.6 for more detail.

The setting made in this section can be saved in the file as a preferred setting for a particular print job.

See Section 3.3.4 for more detail.

3.6.3Label Gap

Notes:

This measurement is ignored if None is specified in Sensor.

The setting made in this section can be saved in the file as a preferred setting for a particular print job.

See Section 3.3.4 for more detail.

See A1.3.2 and A1.3.3 for gap specification.

The type of sensor can be selected, depending on type of media. Click the Sensor down arrow to select the type of sensor, which depends on type of media.

Click Transmissive to use the transmissive sensor. This sensor is designed to locate label gaps by the transmission of light.

Select None, if there is no label gap, notch, or black mark. When None is selected, even if any gap, notch, or black mark is on the label, it is ignored.

Select Reflective to use the reflective sensor. This sensor is designed to locate black marks on the back of the tags by the reflection of light.

Enter the amount of space between labels (label gap) or width of a black mark in Label Gap. If a proper value is not entered, the print start position will be misaligned.

54

Page 62
Image 62
Toshiba CB-416-T3-QQ owner manual Stock, Print Method, Sensor, Label Gap