Chapter 2 Printer Installation
2. Printer Installation
2.1Installing the Accessories
2.1.1Fan Filters
Note:
Please clean the Filter Pads periodically. See Section 5.1.3.
This chapter describes in detail how to set up the printer to get ready for printing.
First install the accessories on the printer.
1Unpack the Fan Filters.
2Mount the Fan Filters over the Air Vents.
Filter Pad
Filter Retainer
Air Vents
(Cooling Fans)
2.1.2Media Slide
Notes:
∙Either a roll of labels or tags can be loaded in the printer.
∙In this Owner's Manual, labels and tags are generically called "media".
∙TOSHIBA TEC recommends that labels are rolled outside, and the tags are rolled inside. The media loading procedure depends on which type of media is going to be loaded. See Section 2.5 for more detail.
Attach the Media Slide with the two supplied black screws.
When loading a roll of labels, fit the Media Slide on the screw holes above the Media Inlet.
or
When loading a roll of tags, fit the Media Slide on the screw holes below the Media Inlet.
Media Slide (for labels)
Media Slide (for tags)
2.1.3 | Supply Shaft Holder | 1 | Connect the Supply Shaft Holder Harness to the harness attached |
|
|
| on the rear of the printer. |
|
| 2 | First hook the lower parts of the Supply Shaft Holder into the |
|
|
| lower two Supply Shaft Holder Slots on the rear of the printer. |
|
|
| Then fix the Supply Shaft Holder in place by tightening the screw. |
To remove the Supply Shaft Holder from the printer, just reverse the installation procedure.
Supply Shaft
Screw | Holder Slots |
| |
| Harness |
Supply Shaft Holder
Supply Shaft Holder Harness
6
