Toshiba CB-416-T3-QQ owner manual Options, Transfer Mode, Print Density Adjustment

Chapter 3 Printing

3.7Options

3.7.1Transfer Mode

Notes:

∙This setting may need to be changed depending on the computer configuration.

∙The setting made in this section can be saved in the file as a preferred setting for a particular print job.

See Section 3.3.4 for more detail.

3.7.2Print Density Adjustment

Notes:

The setting made in this section can be saved in the file as a preferred setting for a particular print job.

See Section 3.3.4 for more detail.

This section describes how to specify the transfer mode of graphics data and make a print density adjustment.

Click the Options tab to open the Options property page.

The type of transfer mode for graphics to the printer is specified here. Run Length Encoding is the recommended transfer mode due to its high transfer rate. When using Uncompressed 8-bit (Overwrite), or Uncompressed 4-bit (Overwrite), the same output as Run Length Encoding can be obtained, but the data transfer speed slows down.

Print density needs to be adjusted to avoid blurred or light print caused by a combination of the media with the ribbon.

Mark the Set Checkbox, and the print density for each color can be adjusted.

The print density value can be adjusted by entering a value or by clicking up or down arrows.

57