
Appendix 5 | System Mode |
The
∙Selection of the media sensor to be used.
∙Performs a
∙Prints out the Maintenance Counter/Parameter Settings.
∙Checks to see if there is any problem with the print head.
<1>DIAG. V1.0
While pressing the FEED and PAUSE keys at the same time, turn on the printer. Hold both keys until the “<1> DIAG.” message appears in the display.
Note:
Use the FEED or RESTART key to select a desired option.
Notes:
∙If any error occurs, an error message appears, and the printer stops printing. After clearing the error, press the PAUSE key to return to “<1> DIAG.”. The printer does not restart printing automatically.
∙See Section A5.7.1 for the Self- Diagnostic Test print sample and descriptions.
Selecting the Media Sensor to be Used
SENSOR NONE
Press the PAUSE key. The type of media sensor can be selected: “NONE” (media positon not detected), “REFLECT.” (Reflective Sensor), or “TRANS.” (Transmissive Sensor).
After selecting the media sensor to be used, press the PAUSE key.
Performing the
AUTO DIAGNOSTIC
The
CHECKING & PRINT
The printer starts the
Print out the Maintenance Counter/Parameter Settings
When the
to “<1> DIAG.”. Press the | PAUSE | key twice. |
MAINTENANCE CONT |
|
|
Note:
See Section A5.7.2 for the Maintenance Counter/Parameter Settings print sample and descriptions.
The printer is ready to print out the Maintenance Counter/ Parameter Settings. Press the PAUSE key to start.
CHECKING & PRINT
The printer starts printing out the Maintenance Counter/Parameter Settings.
91