UBCD396XT

23.Programming locations

To use Location-based Scanning with a particular system, you will need to program your scanner with the geographic coordinates you want to use for each site or channel group. You can also program your scanner to alert you when you approach particular locations.

Programming a location for a site

Each system site can have separate location information.

1.Open the Program System menu.

2.Select the system you want to program for location based scanning.

3.Select Edit Site, then select the first site you want to assign a location to.

4.Select the Set LocationInfo menu and enter the latitude, longitude, and range for this site.

5.Change the Set GPS Enable field to On.

6.Go back to the Edit Site menu and repeat these steps with any other sites you want to program for this system.

Programming a location for a channel group

Each channel group in a system can have separate location information.

1.Open the Program System menu.

2.Select the system you want to program for location based scanning.

3.Select Edit Group, then select the first channel group you want to assign a location to.

4.Select the Set LocationInfo menu and enter the latitude, longitude, and range for this site.

5.Change the Set GPS Enable field to On.

6.Go back to the Edit Group menu and repeat these steps with any other groups you want to program for this system.

Remember: You have to turn on Set GPS Enable before the location information can affect that site or channel group.

Programming general locations

You can program general locations (i.e., locations that are not associated with a site or channel group). There are three types of general locations:

points of interest ( POI )

83

Page 97
Image 97
Uniden UBCD396XT Programming locations, Programming a location for a site, Programming a location for a channel group