USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router manual Pppoestart, Pppoestop

U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide

negotiation starts only when the system identifies any traffic required to be transferred on the link. In case the mode is set to DIRECT, the PPPoE negotiation is started manually using the “pppoestart” command. The default mode is DIRECT.

-idletime <idletime> The value of idletime is given in minutes and this value indicates how long the link remains up when there is no data transfer over the link. The idle time works only when used in combination with mode AUTO. The default is 60 seconds.

-nat enabledisable Enables or disables NAT (Network Address Translation) for this PPP interface. The default is for NAT to be disabled.

-netmask <mask> Specifies the netmask for the PPP interface. The mask is specified in dot notation (i.e. 255.255.255.0).

-vpn <OUI> <vpnId> Specifies the VPN encapsulation. The OUI (Organizationally Unique Identifier) and VPN identifier are specified as numbers.

Example:

pppoe 1 –o -if ppp0 -vpi 0 -vci 100 -user jones -pass Indiana

Defines a PPPoE profile. The ppp0 interface is used with the ATM connection vpi 0 and vci 100. The user name is “jones” and the password is “Indiana”.

1.25.5 pppoestart

pppoestart <Profile>

Starts PPPoE given the specified profile. The profile is specified with an integer (0, 1, 2). The profile was previously specified with the pppoe command.

pppoestop <Profile>

1.25.6 pppoestop

pppoestop <Profile>

Stops PPPoE given the specified profile. The profile is specified with an integer (0, 1, 2). The profile was previously specified with the pppoe command.

pppoestop <Profile>

file:///P/T_WRITER/Documentation/Released/9003%20(Guinness)/User%20Guide/9003%20(Guiness)%20prac%20template/cli.htm (65 of 71) [11/6/2002 8:58:46 AM]