VistaQuest N7227V5 installation instructions Wiring Notes, 4285

4285 WIRING NOTES:

1.Wire the 4285 Phone module exactly as shown, using a direct-connect cord and RJ31X jack.

2.If Touch-tones are not heard when pressing keys following phone access to the security system via an on-premises phone, try reversing the pair of wires connected to terminals 3 & 4 on the 4285, and the pair of wires connected to terminals 17 & 18 on the control.

3.If an error signal (fast busy signal) is heard when trying to access the system via the phone, check for correct line seizure wiring, as described in note 4.

4.Connection to the incoming Telco line via a RJ31X jack and direct-connect cord, as shown in this diagram, is essential, even if the system is not connected to a central station. The 4285 will not function if this is not done.

The house phone lines (gray and brown wires) must be wired to the Phone module terminals, not to the control terminals. Otherwise, an error signal (fast busy signal) will occur when trying to access the system from an on-premises phone.

5.If the telephone system on the premises includes a Caller ID unit, connect the ID unit directly to the “Handset” terminals (17 & 18) on the control, as shown.

TERMINALS	➡
ON CONTROL

CALLER ID

UNIT

IMPORTANT NOTE FOR EXISTING INSTALLATIONS:

EXISTING WIRES CONNECTED TO THE "HANDSET" TERMINALS ON CONTROL MUST BE MOVED FROM THERE TO TERMINALS 3 AND 4 ON THE 4285.

	Handset
	{
CONNECTMUSTTO	17	18
	4285ON (TIP)	CONNECTMUST TO 2 4285ON (RING)
1

IMPORTANT

IF THE PANEL IS NOT CONNECTED TO

Incoming

GROUND

A PROPER EARTH GROUND, YOU MAY

GET FALSE LINE CUT INDICATINS (IF

Telco Line

TELEPHONE LINE MONITOR HAS BEEN

{

PROGRAMMED).

19

20

21

▲ EARTH GROUND (COLD WATER PIPE)

GREEN (TIP)

RED (RING)

INCOMING TELCO LINE

DIRECT

TIP

RING

CONNECT

▲

▲

TIP

CORD

➧

RJ31X

RING

JACK

PREMISES

▲

ANSWERING

PLUG

MACHINE AND

PHONES

BROWN(T)

ANSWERING

(R)

MACHINE

4285			6 7
	VOICE MODULE				5
				1 2 3 4
▲		NOT INSTALLER
		ADJUSTABLE

GRAY	TO GND	*
	TERMINAL (21)
	ON CONTROL
	▲

*

▲

UNUSED

CONNECTOR WITH FLYING LEADS

KEYED

HEADER

➡

YELLOW: TO DATA OUT (term. 7)

NO CONNECTION

RED:	TO AUX (+) (term. 5)
BLACK:	TO AUX. GROUND (–) (term. 4)

GREEN: TO DATA IN (term. 6)

*NOTE: IF THE TELEPHONE HAS BUILT-IN CALLER ID, THE CALLER ID FUNCTION MAY NOT WORK.

				4285
		TERMINAL ASSIGNMENTS
TO CONTROL PANEL	1	- TIP	}	PHONE INPUT
	2	- RING
TERMINALS USED	3	- TIP	}	PHONE OUTPUT
FOR KEYPAD
	4	- RING
CONNECTIONS	5	- GROUND
	76	--} AUDIO OUT 1
		(FOR FUTURE USE)

Figure 10. 4285 Phone module Wiring Connections

– 46 –