VistaQuest N7227V5 installation instructions O R

Default Descriptor ↓

✱ZN 0 1 ZO NE 0 1

Flashing Cursor (system is

ready for entry of word).

↓

✱ZN 0 1 A

Flashing Cursor ↓

✱ ZN 0 1 B ACK

✱ZN 0 1 BACK

A

↑Flashing Cursor if “6” is pressed (system is ready for next word).

✱ZN 0 1 BACK

DO O R

↑Flashing Cursor

4.Press “0” (No).* The system will then automatically display the default descriptor for zone 1.

*The procedure for adding custom words to the built-in vocabulary will be found later under “Adding Custom Words”.

If a descriptor was not entered previously for zone 1, the default descriptor for zone 1 will be displayed.

Note that no entries can be made. Entries can be made only when the display contains a flashing cursor, which signifies the “entry mode”.

5.To delete or change the default descriptor for zone 1, press [ ✱] plus the same zone number (01). This will clear that descriptor and gain access to the entry mode with flashing cursor, allowing changes to be made.

NOTE: If you do not wish to change the existing descriptor for zone 1, enter [✱] plus the next zone number for which you wish to enter (or check) a descriptor. A summary display for that zone will appear. You must then press [✱] plus the same zone number again to gain access to the entry mode (flashing cursor) for that zone.

6.Press # plus 3-digit number for the first word from the “ALPHA VOCABULARY LIST” on a following page. Example: The descriptor that we wish to enter for zone 1 is BACK DOOR. From the list, BACK = 013. Therefore, you would enter # 0 1 3 .

Note: If you accidentally enter the wrong word, simply press # plus the correct 3-digit number for the word you want.

7.Press “6” to accept the selected word and continue.

Note: If this is the only word you are using for the descriptor, press “8” instead of “6 ” to save that word in memory, and then go to step 11.

8.Enter the 3-digit number for the next word. In our example, the word is DOOR, whose number is “057”.

Enter # 0 5 7. This display will appear:

– 57 –