VistaQuest N7227V5 installation instructions Method

4.For selection of the next word (e.g., DOOR), repeat step 3, as follows:

Press key [3] until the first letter of the next word appears (e.g., "D"). Then press [6] to display the first available word beginning with that letter (e.g. DAUGHTERS). Press [3] repeatedly until the desired word (e.g., DOOR) appears. To accept the word, press [6], which toggles back to the alphabet list.

5.When all desired words have been entered, press [8] to store the description in memory.

6.Enter ✱NN, where NN is the next zone that you want to review or for which you want to program a descriptor. To modify the descriptor, enter ✱ NN again. To exit this mode, press “✱00”.

Adding Custom Words (will not be annunciated by 4285 Phone module)

When adding Custom Words in steps 3–6, the keypad keys perform the following functions:

[3]Advances through the alphabet in ascending order.

[1]Moves through the alphabet in descend- ing order.

[6]Selects desired letter; moves cursor one space to right.

[4]Moves cursor one space to left.

[7]Inserts a space at the cursor location, eras- ing any character lo- cated there.

[8]Saves the new word in the system's mem- ory.

You can add up to five installer-defined words can be added to the built-in vo- cabulary. Each of the five "words" can actually consist of a "word string" of one or more words, but no more than ten characters can be used for each word or word string.

Custom words must begin with an alphabetic character. If a number or symbol is used as the first character, the word will not be saved.

1.Perform steps 1, 2, and 3 of Programming the Descriptors on a previous page.

Select CUSTOM WORD mode (enter “1”) when the promptCUSTOM WORD ? is displayed.

2.Enter the number ([1]–[5]) of the custom word or word string to be created (for example, if you are creating the first custom word or word-string, enter [1], for the second , enter [2], etc.). A cursor will now appear at the be- ginning of the second line.

3.One of two methods of entering the custom word's characters can now be used (refer to the CHARACTER (ASCI) LIST of letters, numbers, and symbols on a following page):

Method 1:

Press the [#] key, followed by the two-digit entry for the first letter you would like to display (e.g., [6][5] for "A"), or...

Method 2:

Use the [3] key to advance through the list of symbols, numbers, and letters. Use the [1] key to move back through the list.

4.When you have reached the desired character, press [6] to select it. The cursor will then move to the right, in position for the next character.

5.Repeat steps 3 and 4 to create the desired word(s). Note that the [4] key can be used to move the cursor to the left, if necessary, and that key [7] can be used to enter a blank (or erase an existing character). Remember, no word or word-string can exceed 10 characters.

6.Press the [8] key to save the custom word(s) and return to the "CUSTOM WORD ? " display.

Repeat steps 2–5 for other custom words to be entered. To change a custom word, just overwrite it. If no more are to be entered now, press [0] to return to the Descriptor entry. The custom word(s) will be automatically added to the built-in vocabulary.

When zone descriptors are being entered as described in step 6 of Programming the Descriptors, the custom word numbers are 250 to 254 for words 1 to 5 respectively.

When being entered as described in step 3 in Alternate Method For Programming Zone Descriptors, each word will be found at the end of the group of words that begin with the same letter as it does.

– 59 –