4204 Relay Unit (if installed in cabinet)
1.Insert
2.Hang the unit on the screw heads via two of the slotted holes at the rear of its housing, as shown in Figure 2.
3.The 4204's cover can be left off if the unit's DIP switch is set with its position 1 "ON" (to the right) as shown in its instructions. The tampered cover is necessary for installations outside of the control's cabinet.
CIRCUIT |
BOARD |
CABINET |
DETAIL B |
|
|
SIDE VIEW OF |
| DETAIL A |
LONG MOUNTING CLIPS | CONTROL | SIDE VIEW OF |
| BOARD SUPPORTING SLOTS | |
| CIRCUIT | |
|
| |
| BOARD |
|
Figure 2. Installing The PC Board in the Cabinet Alone, or (if used), With a 4204 Relay Unit
Figure 3. Installing The PC Board And RF Receiver Together In The Cabinet
– 12 –
