VistaQuest N7227V5 installation instructions Serial # ↑

10 Input S/N:	L	5. This prompt is displayed when the system has found the next zone
			which needs to be enrolled.
Axxx xxxx
			The system will respond to the first serial number transmitted. A serial
			number may be enrolled by one of two methods:
			a) Enter the 7 digit serial number printed on the transmitter
			or
			b) Activate the transmitter by faulting or restoring the input you wish to
			use for that zone (e.g., press a button, open or close a door, etc.).
			If you do not wish to enroll the zone displayed, press the [#] key on
			the keypad or the upper right-hand button on the program tool (a long
			beep will be heard to verify). The following prompt will appear:
			10 Learn S/N?
			0 = No, 1 = Yes	0
			To enroll now, enter "1" (Yes). If "0" (No) is entered, the following
			prompt will appear if a program tool has already been programmed:
			Ente r Zn Num .
			(0 0 = Q uit)	1 2
			Zone Number Entered ↑

Enter the next zone number to be enrolled (e.g., zone 12). The system will search for that zone and will display the prompt shown in the beginning of step 5. If you wish to exit the enroll mode completely, enter 00 and press [✱].

10 Input S/N:		L	The system will enroll the serial number of the first transmitter heard, add
			the loop number entered to this serial number, display the serial and loop
A 022-4064		3
			numbers, and cause the keypad to beep twice.
Serial # ↑	Loop # ↑

10Confirmed

A022-4064 3

If the serial and loop number combination is already present in the system, a single long beep will be heard from the keypad. If this happens, the system will not display the serial number, but will wait for a transmission from another transmitter or transmitter loop input.

6.The system will then enter a confirmation mode so that the operation of the actual programmed input can be confirmed. Activate the loop input or button that corresponds to this zone. We recommend that you confirm the programming of every transmitter before proceeding to the next zone.

When the system sees activity on the appropriate input, it will beep three times and display the confirmation message. Press [ ✱] or the upper left-hand button of the program tool when you are ready to enroll the next transmitter.

At any time during this step, you may press the [ ✱] key on the keypad or the upper left-hand button of the program tool if you are satisfied with the serial and loop number combination that has been enrolled, regardless of whether or not the enrolled input has been "confirmed." This will ready the system to enroll the next transmitter.

If the incorrect transmitter has been enrolled, press the [#] key on the keypad or the upper right-hand button of the program tool to delete the serial number and return to the "LEARN S/N" prompt. A single long beep will be heard from the keypad to verify pressing of the upper right-hand button. Then, press "1" (Yes) or press the upper left-hand button of the program tool (a single short beep will verify the system is ready for enrolling) and re-activate the proper transmitter or transmitter loop input.

– 62 –