Section 2. INSTALLING THE CONTROL
This section provides instructions for mounting the control cabinet, and installing the cabinet lock (if used). Also included in this section are instructions for the following:
•Installing the main PC board (and 4204 Relay Unit, if used).
•Mounting the RF Receiver board (if used) in the cabinet.
•Standard phone line connections.
•Installing the
•Connecting the AC transformer.
•Making earth ground connections.
Mounting the Cabinet
Mount the control cabinet to a sturdy wall using fasteners or anchors (not supplied), in a clean, dry area which is not readily accessible to the general public. Four mounting holes are provided at the back of the cabinet.
If an RF Receiver is being used and you intend to mount its PC board within the cabinet, note the following:
•Do not mount the cabinet on or near metal objects. This will decrease RF range and/or block RF transmissions from wireless transmitters.
•Do not locate the cabinet in an area of high RF interference (revealed by frequent or prolonged lighting of the LED in the receiver after it is operational). Random flicker is OK.
Installing the Lock (if used)
Use an Ademco No. N6277 Cam Lock and No.
Note: The cabinet can be closed and secured without a lock by using 2 screws in the cover's edge.
LOCKED
RETAINER
CLIP
UNLOCKED
RETAINER CLIP |
(NOTE POSITION) |
RETAINER |
SLOTS |
1.Remove the cabinet door. It is easily removable for servicing and is easily re- installed.
2.Remove the lock knockout from the control cabinet door. Insert the key into the lock. Position the lock in the hole making certain that the latch will make contact with the latch bracket when the door is closed.
CABINET DOOR BOTTOM
Figure 1. Installing the Lock
3.Hold the lock steady, and in - sert the retainer clip into the retainer slots. Position the clip as illustrated in order to permit easy removal.
Before installing the cabinet's contents, remove the metal cabinet
Installing the Control's Circuit Board Alone, or (if used), with a 4204 Relay Unit
Control's Circuit Board 1. Hang two long Red mounting clips (provided) on the raised cabinet tabs (see Detail B in Fig. 2).
2.Insert the top of the circuit board into the slots at the top of the cabinet. Make sure that the board rests on the correct row (see Detail A in Fig. 2).
3.Swing the base of the board into the mounting clips and secure the board to the cabinet with the accompanying screws (see Detail B in Fig. 2).
– 11 –
