VistaQuest N7227V5 installation instructions Sequential Mode For 5800 Series Wireless Transmitters

Section 13. SEQUENTIAL MODE

(for 5800 Series Wireless Transmitters)

(Use this mode only after all other zone information has been programmed, including transmitter loop numbers).

There are two methods of enrolling – you can enroll each transmitter into the system as you are entering the zone information in field ✱56 (the procedure will be found in the WIRELESS (RF) ZONE EXPANSION section), or you can enroll all the transmitters in ✱83 menu mode after all other zone information has been entered in field ✱56.

The enrolling method in ✱83 is called "sequential enrolling" and is described in this section.

As an option, the new sequential mode allows you to use a 5804 button-type transmitter as a "program tool." The advantage of using a program tool is that it enables remote enrollment. You can move to the physical location of the transmitter to be enrolled, press the upper left-hand button of the program tool, and then trip the intended transmitter (see step 10 for operation). The transmitter that you use as the program tool can also be used as a transmitter in the system. If you plan to use an existing transmitter, it must first be enrolled into the system as its associated zones. You may then program it as the tool.

A Custom English keypad is required for the following procedures.

To enroll transmitters sequentially, after all other zone information has been programmed, do the following:

		1.		Enter Programming mode [Installer Code ] + 8 + 0 on a Custom
				English keypad. Enter the Serial Number Sequential mode by pressing
				✱83. The following prompt will be displayed.
		2.		If using a program tool, enter "1." If not using a tool, enter "0." If a tool
Program Tool?
				has already been programmed, this prompt will not appear. If either
0 = No, 1 = Yes	0
				not using a tool or one has already been programmed, skip to step 4.
			3. If "1" is entered, the system will prompt for the transmitter’s serial
00 Input S/N:	L
				number. Enter the program tool’s serial number using one of the
Ax x x-x x x x
				following methods:
				a) Enter the 7-digit serial number printed on the transmitter
				or
				b) Press any button on the transmitter. The keypad should beep
				twice and display the serial number of the tool.
				In this example, the serial number is A123-4567. Once enrolled, the
00 Input S/N:	L
				upper left-hand button of the program tool can be pressed to ready the
A123-4567	3
				system for enrolling a transmitter into the system.
				The serial number for the program tool will only remain in the
				system until the programming mode is exited. (Entering ✱97 will
				not delete the tool.)
				Press [✱] to continue.
				Note that pressing the [#] key on the keypad will cause the system to
				back up to the "Program Tool ?" prompt.
			4. Enter the first zone number to be enrolled (e.g., zone 10).
Ente r Zn Num .
				Press [✱] to continue.
(0 0 = Q uit)	1 0
				The system will, starting with this zone number, search for the first
Zone Number Entered	↑			transmitter which has all of the following attributes pre-programmed in
				Zone Programming:
				a) An input type of RF, UR, or BR programmed
				b) A loop number programmed
				c) No serial number programmed
			If the first zone number entered does not have one or more of the above
			attributes, the system will search its database for the first zone that does
			and will display it on the next screen.

– 61 –