Xerox 100, 180 EPS manual Maintaining the system, Remove the cap from a new bottle of fuser agent

Maintaining the system

5.Pull the fuser agent reservoir out until it stops.

6.Remove the reservoir cap by turning it counterclockwise.

7.Remove the cap from a new bottle of fuser agent.

WARNING: If any fuser agent spills on the floor, remove it immediately. Fuser agent spills make the floor slippery.

CAUTION: The fuser reservoir has an antisplash seal. Do not push the fuser agent bottle into the reservoir with excessive force, as this can damage the seal.

8.Carefully pour the fuser agent into the reservoir, until the level reaches the MAX line.

Figure 4-6Pour fuser agent to MAX line

9.Replace the reservoir cap by turning it clockwise.

10.Push the fuser agent reservoir in until it stops.

11.Push the fuser drawer in until it latches in place.

4-6 Operator Guide