Xerox 100, 180 EPS manual Spooling mode, Points to note, Troubleshooting

Troubleshooting

The Online Gateway was unable to recover the current job due to an internal error.

	Job <job ID> aborted.
	Select Reset to clear fault.
	This message displays when the Online gateway encounters an
	internal error during a crash recovery and the system aborts the
	job. The job status shows the state of the job. If the job specifies
	an accounting page, the page is generated. The accounting log
	displays the Job Aborted status.
Example 3	Short message:
	Job <job ID>: LCDS Decomposer could not
	recover data. Job will be ended
	prematurely.
	Long Message:
	Job <job ID>: LCDS Decomposer could not
	recover data. Job will be ended
	prematurely.
	This message is displayed when the LCDS Decomposer
	encounters an internal error during recovery. Upon clicking
	Continue in the Printer Fault Clearance window, the job is aborted.
	The job status shows the Job Aborted state. No accounting page
	is generated.

Spooling mode

In Spooling mode, a job does not print until all its data is received.

If the system crashes after spooling all the data, follow the directions for Streaming mode. If the system crashes while receiving data, the job is aborted.

After a crash, wait until the system is idle before restarting. Wait for the printer engine to cycle down and make sure that the Job Manager shows no changes in the job state.

Points to note

•If automatic recovery is possible and the same system fault occurs twice within the report, the system prints any formatted reports, but aborts the current job. If there are system faults that do not result in restarting the system, the system does not print the reports.

Automatic recovery refers to restarting of the system software following a system fault such as when a critical component dies.

•You may change the buffer size that determines how many

5-1 2 Operator Guide