Xerox 180 EPS, 100 manual Troubleshooting stacker problems, Troubleshooting paper curl problems

Troubleshooting

Troubleshooting stacker problems

The following stacker problems may occur during printing.

•Problem: Papers are being thrown around in the stacker.

This problem may occur when you have unloaded paper by opening the top cover of the stacker bin.

NOTE: Do not open the top cover of the stacker bin to unload paper.

To remedy this situation, unload the bin following the normal procedure.

•Problem: The paper stack is falling over or sliding around in the bin.

This problem may be due to excessive paper curl. Try the following:

–Reduce the paper curl by adjusting the decurler. Refer to the section, “Troubleshooting paper curl problems”.

–Reduce the number of sheets going to the bin.

Troubleshooting paper curl problems

Too much curl in the paper stock can cause paper jams.

Checking paper curl

You can adjust the decurler lever to correct most paper curl problems. Refer to the paper curl chart, later in this chapter, to determine the amount of curl in the paper stock.

Perform the following to measure paper curl:

1.Print five one sided (simplex) 8.5 by 11 inch or A4 sheets.

2.Hold the printed sheets by the top center of the short edge, keeping the image toward you.

Operator Guide 5- 37