Xerox 180 EPS, 100 Using the custom transfer assist blade, Maintaining the system, Operator Guide

Maintaining the system

Figure 4-15Move green handle to left

9.Hold the cartridge in place and pull off the paper seal.

10.Discard the seal along with the drop cloth.

11.Close the printer doors.

NOTE: If any dry ink gets on your hands, wash them with soap and cold water. Heat sets the ink permanently. If any dry ink gets on your clothes, brush them with a dry paper towel or a stiff bristled brush. If this does not remove the ink immediately, launder with detergent and cold water. Dry cleaners should be told that the spot is dry ink for a printer, so they will not use a solvent that sets the stain.

Using the custom transfer assist blade

The custom transfer assist blade in the printer assures good print quality for your jobs. A kit is available allowing you to customize the transfer assist blade for use with nonstandard paper sizes.

You cannot use the custom transfer assist blade for print jobs that use more than one paper size. In addition, the following paper lengths cannot use the blade:

•In U.S. markets

–11.1 to 11.4 inches/282 to 290 mm

–11.8 to 12.1 inches/300 to 307 mm

–13 to 13.5 inches/330 to 343 mm

•In non-U.S. markets

Operator Guide 4- 13