Xerox 100, 180 EPS manual Stacker bins, Overview

Overview

	Figure 1-5 Feeder tray control panel
	1.	Ready to Open indicator on feeder trays
	2.	Please Wait indicator on feeder trays
	3.	Tray Unlock button (feeder)
	4.	Paper Level indicators on feeder trays
Ready to Open	Glows green when the tray can be pulled out and paper can be
indicator on	added to it.
feeder trays
Please Wait	Shows that the tray is in motion. This indicator is lit red when the
indicator on	Tray Unlock button is pressed, while the tray is lowering, and while
feeder trays	the tray is rising. The indicator goes off when the tray elevator
	reaches its destination.

Tray Unlock button (feeder)

Paper Level indicators on feeder trays

Enables the feeder tray to be opened.

•If the tray is in use when this button is pressed, the feed selection switches to the backup tray if one has been identified. Otherwise, printing stops.

•If the tray is in use and selected as a backup tray, pressing the Tray Unlock button causes the tray elevator to lower and the tray to be unavailable for auto switching.

•If the tray elevator is in the raised position and the tray is not in use or selected as a backup tray, pressing this button causes the elevator to lower with no effect on printing operations.

This button functions when the Please Wait indicator is off.

Display the approximate quantity of paper in the tray. Each display shows paper by quarter reams up to one ream, and then by full reams. The green indicator appears above its Paper Level indicator.

Stacker bins

Each output stacker bin has offsetting capability and a capacity of 2500 sheets of 20 pound or 80 gsm paper.

NOTE: This capacity does not apply to 11 by 17 inch and A3 papers. Because of the additional weight these large sheets add to the bins, each bin is restricted to hold only up to 1500 sheets of A3 or 11 by 17 inch papers, for safety reasons.

1-1 2 Operator Guide