Xerox 100, 180 EPS Restarting the DocuSP software, Powering off the system, Managing the system

Managing the system

4.Click [Yes] on the confirmation window.

5.When the DocuSP Print Services window closes and an ok prompt appears at the bottom of the screen, enter boot.

6.When the DocuSP Print Services window reopens, release all held queues. (Refer to “Releasing queues,” earlier in this chapter.)

Restarting the DocuSP software

1.On the DocuSP Print Services window, log on as Administrator or Operator.

2.Hold any active queues. (Refer to “Holding queues,” earlier in this chapter.)

3.On the DocuSP Print Services window, select [Restart] from the System menu.

4.Wait for the DocuSP Print Services window to close and reopen.

5.Release all held queues. (Refer to “Releasing queues,” earlier in this chapter.)

Powering off the system

You may be required to power down the system under the following conditions:

•Work is being done on an attached printer.

•The Sun workstation is being moved.

•SCSI peripherals are being added or removed.

•A power outage is planned.

•The Sun workstation is receiving hardware maintenance.

•The DocuSP controller will not be in use for an extended period.

The Sun workstation should run continuously. Refer to the Sun hardware manuals for recommendations for when to power off the system.

CAUTION: Do not shut down DVD players and SCSI tape drives unless you are powering off the entire system.

1.Log on as Administrator or Operator.

2.Hold any active queues. (Refer to “Holding queues,” earlier in this chapter.)

3.Select [Printer Off] from the Printer menu.

4.Select [Shutdown] from the System menu.

3-4 Operator Guide