Xerox 7242, 7232 manual Server Fax Overview

15 Server Fax

This chapter explains how to set up the Server Fax feature of the machine. The following information is provided.

Server Fax Overview – page 157

Information Checklist – page 157

Server Fax Environments – page 158

Server Fax Installation – page 158

Installation Procedure – page 158

Network Communication Setup – page 158

Test Server Fax transmission – page 162

Server Fax Overview

If your machine is installed with both the optional scanner kit and the optional server fax kit, you can use the Server Fax feature that sends and receives image data through a Server Fax server.

NOTE: The Server Fax feature cannot be used concurrently with the Fax feature or the Internet Fax feature. While the Fax Server feature is enabled, the Fax feature is detected as "not installed" even if the fax feature is supported on the machine. During that time, therefore, fax transmission and reception are disabled and printed reports show that the machine does not support the Fax feature.

Information Checklist

Before enabling this feature, make sure that the following items are available or have been performed.

	Item	By
An existing operational network utilizing TCP/IP is required. These		Customer
procedures are not designed to install a network.
Obtain and record the following information:		Customer
•	IP address
•	Gateway address
• Subnet mask (for IPv4) / Prefix (for IPv6)
•	Host name
Refer to the Glossary for additional information about the Gateway Address
and Subnet mask.
Test the machine to make sure that it is installed fully and functioning		Customer
correctly.

Xerox WorkCentre 7232/7242 System Administration Guide 157