ZyXEL Communications wireless n gigbit router zyxel manual 143, DNS Servers First DNS, Computer’s

	Chapter 8 WAN
Table 49 Network > WAN > Internet Connection: PPPoE Encapsulation
LABEL	DESCRIPTION
Retype to	Type your password again to make sure that you have entered is
Confirm	correctly.
Nailed-Up	Select Nailed-Up Connection if you do not want the connection to time
Connection	out.
Idle Timeout	This value specifies the time in seconds that elapses before the router
	automatically disconnects from the PPPoE server.
WAN IP Address Assignment
Get	Select this option If your ISP did not assign you a fixed IP address. This
automatically	is the default selection.
from ISP
Use Fixed IP	Select this option If the ISP assigned a fixed IP address.
Address
My WAN IP	Enter your WAN IP address in this field if you selected Use Fixed IP
Address	Address.
DNS Servers
First DNS	Select From ISP if your ISP dynamically assigns DNS server information
Server	(and the NBG-460N's WAN IP address). The field to the right displays
Second DNS	the (read-only) DNS server IP address that the ISP assigns.
Server	Select User-Definedif you have the IP address of a DNS server. Enter
Third DNS	the DNS server's IP address in the field to the right. If you chose User-
	Defined, but leave the IP address set to 0.0.0.0, User-Defined
Server
	changes to None after you click Apply. If you set a second choice to
	User-Defined, and enter the same IP address, the second User-
	Defined changes to None after you click Apply.
	Select None if you do not want to configure DNS servers. If you do not
	configure a DNS server, you must know the IP address of a computer in
	order to access it.
WAN MAC	The MAC address section allows users to configure the WAN port's MAC
Address	address by using the NBG-460N’s MAC address, copying the MAC
	address from a computer on your LAN or manually entering a MAC
	address.
Factory default	Select Factory default to use the factory assigned default MAC
	Address.
Clone the	Select Clone the computer's MAC address - IP Address and enter
computer’s	the IP address of the computer on the LAN whose MAC you are cloning.
MAC address	Once it is successfully configured, the address will be copied to the rom
	file. It will not change unless you change the setting or upload a
	different ROM file.
Set WAN MAC	Select this option and enter the MAC address you want to use.
Address
Apply	Click Apply to save your changes back to the NBG-460N.
Reset	Click Reset to begin configuring this screen afresh.

NBG-460N User’s Guide

143