Chapter 3 Introducing the Web Configurator

Select a language to go to the basic Web Configurator in that language. To change to the advanced configurator see Chapter 23 on page 297.

Figure 11 Selecting the setup mode

3.3 Resetting the NBG-460N

If you forget your password or IP address, or you cannot access the Web Configurator, you will need to use the RESET button at the back of the NBG-460N to reload the factory-default configuration file. This means that you will lose all configurations that you had previously saved, the password will be reset to “1234” and the IP address will be reset to “192.168.1.1”.

3.3.1 Procedure to Use the Reset Button

1Make sure the power LED is on.

2Press the RESET button for five seconds or until the power LED begins to blink and then release it. When the power LED begins to blink, the defaults have been restored and the NBG-460N restarts.

3.4Navigating the Web Configurator

The following summarizes how to navigate the Web Configurator from the Status screen in Router Mode and AP Mode.

NBG-460N User’s Guide

37

Page 37
Image 37
ZyXEL Communications wireless n gigbit router zyxel manual Resetting the NBG-460N, Navigating the Web Configurator