ZyXEL Communications wireless n gigbit router zyxel manual 209

	Chapter 15 IPSec VPN
Table 69 Security > VPN > General > Rule Setup: IKE (Advanced) (continued)
LABEL	DESCRIPTION
Remote Address	For a single IP address, enter a (static) IP address on the network
	behind the remote IPSec router.
	For a specific range of IP addresses, enter the beginning (static) IP
	address, in a range of computers on the network behind the remote
	IPSec router.
	To specify IP addresses on a network by their subnet mask, enter a
	(static) IP address on the network behind the remote IPSec router.
Remote Address	When the remote IP address is a single address, type it a second time
End /Mask	here.
	When the remote IP address is a range, enter the end (static) IP
	address, in a range of computers on the network behind the remote
	IPSec router.
	When the remote IP address is a subnet address, enter a subnet
	mask on the network behind the remote IPSec router.
Remote Port Start	0 is the default and signifies any port. Type a port number from 0 to
	65535. Some of the most common IP ports are: 21, FTP; 53, DNS;
	23, Telnet; 80, HTTP; 25, SMTP; 110, POP3.
Remote Port End	Enter a port number in this field to define a port range. This port
	number must be greater than that specified in the previous field. If
	Remote Port Start is left at 0, Remote Port End will also remain at
	0.
Authentication Method
My IP Address	Enter the NBG-460N's static WAN IP address (if it has one) or leave
	the field set to 0.0.0.0.
	The NBG-460N uses its current WAN IP address (static or dynamic) in
	setting up the VPN tunnel if you leave this field as 0.0.0.0. If the
	WAN connection goes down, the NBG-460N uses the dial backup IP
	address for the VPN tunnel when using dial backup or the LAN IP
	address when using traffic redirect.
	Otherwise, you can enter one of the dynamic domain names that you
	have configured (in the DDNS screen) to have the NBG-460N use
	that dynamic domain name's IP address.
	The VPN tunnel has to be rebuilt if My IP Address changes after
	setup.
Local ID Type	Select IP to identify this NBG-460N by its IP address.
	Select Domain Name to identify this NBG-460N by a domain name.
	Select E-mailto identify this NBG-460N by an e-mail address.

NBG-460N User’s Guide

209