ZyXEL Communications wireless n gigbit router zyxel Dhcp General Screen, Dhcp Advanced Screen

Chapter 10 DHCP

10.4 DHCP General Screen

Use this screen to enable the DHCP server. Click Network > DHCP. The following screen displays.

Figure 110 Network > DHCP > General

The following table describes the labels in this screen.

Table 55 Network > DHCP > General

LABEL	DESCRIPTION
Enable DHCP	DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC
Server	2132) allows individual clients (computers) to obtain TCP/IP
	configuration at startup from a server.
	• Leave the Enable DHCP Server check box selected unless your
	ISP instructs you to do otherwise.
	• Clear it to disable the NBG-460N acting as a DHCP server.
	When configured as a server, the NBG-460N provides TCP/IP
	configuration for the clients. If not, DHCP service is disabled and
	you must have another DHCP server on your LAN, or else the
	computers must be manually configured. When set as a server, fill
	in the following four fields.
IP Pool Starting	This field specifies the first of the contiguous addresses in the IP
Address	address pool for LAN.
Pool Size	This field specifies the size, or count of the IP address pool for LAN.
Apply	Click Apply to save your changes back to the NBG-460N.
Reset	Click Reset to begin configuring this screen afresh.

10.5 DHCP Advanced Screen

This screen allows you to assign IP addresses on the LAN to specific individual computers based on their MAC addresses. You can also use this screen to configure the DNS server information that the NBG-460N sends to the DHCP clients.

158

NBG-460N User’s Guide